After a leak, the surfaces dry fast while the structure stays wet. Framing, subfloors, and wall cavities hold moisture you cannot see. Structural drying uses measured airflow and dehumidification to bring those materials back to normal moisture levels.
One free call connects you with an independent local specialist. Areas served include zip codes 87901 87935.

We are a referral line, not a contractor. Calls are routed to independent local pros around Truth or Consequences who treat drying as a measured process with daily readings and written logs.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
Daily logs track humidity and material readings so drying decisions are based on data.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
You will see equipment day rates and an estimated drying timeline before setup.

The goal is simple: get every wet material back to the moisture level of similar dry materials in the house, and prove it with readings.

Pin and pinless meters plus an infrared camera show exactly where water traveled, including under cabinets, inside walls, and across the subfloor.
Sealing off the wet area with plastic focuses the equipment and shortens drying time.
Small holes behind baseboards let injection systems push dry air into wall cavities, which can avoid tearing out drywall that is otherwise sound.
Hardwood and subfloors are dried with mats and controlled airflow to reduce cupping.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
A local contractor calls back with an arrival time and brings meters, a thermal camera, and an initial set of drying equipment.
The pro maps moisture, records dry standard from unaffected areas, calculates equipment needs, and gives you a written estimate.
Drying continues with daily monitoring until readings confirm the job is done.
Closing up wet framing is how mold starts.
We had fans running for a week after a leak and it still smelled. The drying contractor found wet studs with a thermal camera and had them dry in four days with real equipment.
Laura F.Hidden wet framing after leakThey drilled small holes behind the baseboards and pumped dry air into the walls. We did not have to tear out any drywall.
Kevin Y.Wall cavity dryingI liked seeing the daily log. Humidity numbers, wood readings, all of it. The adjuster liked it too.
Mariah S.Insurance drying documentationOur oak floor was cupping. They used floor mats and kept the drying slow and steady. The boards flattened back out.
Henry L.Hardwood floor drying

Typically three to five days, longer for hardwood, plaster, or concrete.
Household units move far less air and cannot reach the low humidity levels needed to pull moisture out of framing and subfloors. Drying slowly also gives mold time to grow.
Dry standard is the normal moisture reading of the same type of material in an unaffected part of the home. Drying is complete when wet materials match it.
Grains per pound, or GPP, measures how much water vapor is in the air. Lowering GPP in the drying area speeds evaporation from wet materials.
It is loud and warm. Closing off the drying area helps at night.
No. A Water Damage is a free referral service that connects you with independent, licensed and insured local contractors who perform the drying.

Independent drying specialists in the network serve Truth or Consequences, NM and nearby zip codes like 87901 87935.
See nearby cities in the list below.
