Find the water first, then the mold
When a room smells like a damp cellar but every surface looks clean, moisture is hiding behind a finish. One call routes you to an independent, licensed and insured inspector in Kokomo who maps moisture, scans with an infrared camera and tells you where the source is.
ESS Mold Inspection is a free referral line. Every inspection is performed by an independent local contractor, never by the line itself.
What an inspection actually is
A real mold inspection is a field investigation, not a sales visit. The inspector walks the property room by room, looks at ceilings, baseboards, window sills and the backs of closets, and takes moisture readings along the way. Pin-type meters push two small probes into drywall or trim to read moisture content at that exact spot, while pinless meters sweep across a wall to find damp zones without leaving marks. Those readings get plotted on a sketch of the floor plan, which is what people in the trade call moisture mapping.
An infrared camera doesn't actually see mold. What it picks up is temperature, and since evaporating moisture cools a surface, damp spots behind paint show up as cooler patches that the inspector then confirms with a meter. A hygrometer gives relative humidity and dew point for each area. If the dew point sits close to the surface temperature of a wall, a duct or a window frame, condensation is forming there. When something looks suspicious inside a wall cavity, many inspectors drill a hole about the width of a pencil and look in with a borescope rather than opening up the drywall.
The step most people skip is the one that matters most: finding where the water comes from. Kill the mold without fixing the source and it grows back, often within a season. That's why the inspector checks the HVAC air handler, the evaporator coil, the condensate drip pan and drain line, the attic decking and vents, and the crawl space vapor barrier and joists, not just the room that smells. Callers in Kokomo usually reach the line for one of a few reasons: a home purchase, a past leak they're not sure was dried, a smell that won't quit, or a dispute with a landlord.
What you should expect
Callers use the line because it connects them with inspectors who do the moisture work properly and stay out of the remediation business on that job.
Every inspector the line routes to runs an independent business with liability coverage and any state mold assessor license that applies. Some states also bar the company that writes the protocol from doing the remediation on the same job, and even where it's legal, keeping them separate means nobody profits from inflating the scope.
A home purchase with a short option period can't wait two weeks for an inspector. Mention your closing or contingency date on the call and the dispatcher prioritizes inspectors around Kokomo who can get out soon; same-day is common for an active leak.
Inspection pricing usually depends on square footage, the number of areas, and whether attic and crawl space access is needed. You get the price before anyone arrives, and if lab samples might be added on site, ask how they're billed per sample before the visit.
The kit should include a thermal camera, both styles of moisture meter, a hygrometer for humidity and dew point, and a borescope for looking inside wall cavities. If the person who shows up carries a swab kit but no meter, that's not an inspection.
Inspection types
Different situations call for different inspections, and the dispatcher will ask a few questions so the right inspector shows up with the right gear.
This one is timed to your contingency window and focuses on the signs sellers sometimes paint over: ceiling stains, swollen trim, a rusty water heater pan, white mineral bloom on foundation walls.
For the musty smell with nothing visible, the inspector works the odor like a trail, checking under sinks, behind the washer, around tub surrounds and along exterior walls with a thermal camera and meter.
A clogged condensate line or a pan that never drains can feed growth on the evaporator coil and inside the air handler cabinet, then push that odor through every supply register.
Up top, it's about ventilation and roof leaks: blackened sheathing, rusty nail tips, crushed insulation and bathroom exhaust ducts that end in the attic instead of outside. Below, it's joist moisture, a torn or missing vapor barrier, standing water and grading that sends rain toward the foundation.
After the cleanup crew says they're done, an independent inspector checks that the protocol was followed: visible growth gone, framing dry, containment still intact, and the original moisture source repaired. If you also want lab clearance, that's a separate step and the inspector can tell you whether it makes sense.
Call the line and get matched with a local independent inspector who'll trace the water, document it and hand you a written scope.
How it works
From the first call to the written report, here's what the process looks like.
Expect a few quick questions: the reason for the visit, square footage, access to the attic and crawl space, and any closing date.
A local inspector calls to set the appointment; active water problems are prioritized. It helps to clear the path to the attic hatch, the furnace closet and the crawl space door.
Room by room, the inspector takes meter readings, runs thermal scans, records humidity and dew point, and works through the mechanical systems. Any extra work, like lab samples, gets priced before it's done.
You receive a written report with photos, readings, the likely moisture source and a remediation scope you can take to any contractor.
From the dispatch log
These are the kinds of inspection calls that come in every week.
A homeowner called about a musty smell that got worse every time the air conditioning kicked on, with no visible growth anywhere. The inspector found the condensate drain line clogged with slime, the drip pan overflowing, and wet insulation inside the air handler cabinet. Thermal imaging showed a damp patch on the closet ceiling below.
Outcome: The report pointed to the drain line and air handler, not the bedrooms, so cleanup stayed small and focused.
With less than a week before the contingency deadline, a buyer called because a single ceiling had suspiciously fresh paint. The inspector's pinless meter found elevated moisture under the paint, and a borescope through a small hole showed staining on the back of the drywall from a leaking shower valve above.
Outcome: The buyer used the written report to negotiate a repair credit before the option period closed.
After an upstairs dishwasher leak, a condo owner wanted to know whether the shared ceiling had actually dried out. Weeks later the kitchen ceiling had a faint ring. Moisture mapping found the wet area ran past the ring, and the dew point readings ruled out condensation as the cause.
Outcome: The report documented the extent of the moisture so the owner had evidence for the association and insurance.
A family called because allergy symptoms kept flaring at home, but they couldn't find mold anywhere. Room humidity sat near 70 percent. The inspector found a crawl space with a torn vapor barrier, damp joists, and gaps letting crawl space air into the return duct.
Outcome: The scope covered the vapor barrier, air sealing and humidity control, and the family took the report to their doctor.
These are composite examples based on common calls to the line, not individual customer reviews.
Questions
Call the line and get routed to an independent, licensed inspector near Kokomo.
Call +1-844-326-4757Inspection answers where and why. It's a site visit built on moisture readings, thermal scans and tracing the water source. Testing only refers to the lab samples, and many inspections skip them, since a wet wall with visible growth doesn't need a lab to confirm it.
Most houses take somewhere between two and three hours from arrival to wrap-up. Add time for a large footprint, a hard-to-reach crawl space, extra air handlers, or several spots that need a borescope look. Expect the report a day or two after the visit.
Usually not. Surface tools do most of the work, and a cavity check usually means one small drilled hole for a borescope that's easy to patch. If the inspector wants to open more than that, they should ask you first, and a tenant should get the landlord's okay.
In most cases, yes. When the company that finds the mold also gets paid to remove it, there's an obvious incentive to write a bigger scope. Some states prohibit one company from doing both on a single job, and even where it's allowed, a separate inspector gives you a scope you can take to several remediators.
It's not required, but it's worth it if the house shows any history of water: a finished basement, a crawl space, an older roof, or fresh paint in odd spots. Schedule it right after your offer is accepted, so you have the report while you can still renegotiate or walk away.
A useful report has photos of each problem area, moisture readings and where they were taken, humidity and dew point by room, and thermal images with notes. The part you'll use most is the protocol, which spells out what to remove, the containment and air filtration, the moisture repair, and how the finished job gets checked.
Service area
The line routes inspection calls throughout Kokomo, from older homes with plaster walls and original ductwork to newer builds with tight envelopes that trap humidity. The dispatcher matches you with a nearby independent inspector who works separately from the cleanup side.
If there's a closing date, say so at the start of the call. For an active leak, shut off the water if you can and call the line so a local inspector can trace how far the moisture has spread.
