After a leak, the surfaces dry fast while the structure stays wet. Framing, subfloors, and wall cavities hold moisture you cannot see. Structural drying uses measured airflow and dehumidification to bring those materials back to normal moisture levels.
Free referral to independent, licensed and insured local pros. Zip codes served include 39837.

We are a referral line, not a contractor. Calls are routed to independent local pros around Colquitt who treat drying as a measured process with daily readings and written logs.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
The contractor records temperature, relative humidity, GPP, and material moisture each day, then adjusts equipment based on the numbers.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
Drying is usually billed by equipment per day plus monitoring visits. You get the rates and an estimated number of days in writing.

Good drying starts with a moisture map and ends with readings that match dry standard. Everything in between is about controlling air, temperature, and humidity.

Pin and pinless meters plus an infrared camera show exactly where water traveled, including under cabinets, inside walls, and across the subfloor.
Sealing off the wet area with plastic focuses the equipment and shortens drying time.
Small holes behind baseboards let injection systems push dry air into wall cavities, which can avoid tearing out drywall that is otherwise sound.
Hardwood and subfloors are dried with mats and controlled airflow to reduce cupping.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
The pro arrives with moisture meters, infrared camera, and drying gear.
You get a moisture map, a dry standard baseline, and a written drying plan with costs.
Equipment runs with daily readings and adjustments until every material reaches dry standard, then it is removed and the log is handed over.
Get readings before you rebuild.
A week of box fans did nothing. The pro found wet framing with infrared and dried it properly in four days.
Laura F.Hidden wet framing after leakThey drilled small holes behind the baseboards and pumped dry air into the walls. We did not have to tear out any drywall.
Kevin Y.Wall cavity dryingThe daily drying logs were detailed and made the insurance claim straightforward.
Mariah S.Insurance drying documentationOur oak floor was cupping. They used floor mats and kept the drying slow and steady. The boards flattened back out.
Henry L.Hardwood floor drying

Typically three to five days, longer for hardwood, plaster, or concrete.
Household units move far less air and cannot reach the low humidity levels needed to pull moisture out of framing and subfloors. Drying slowly also gives mold time to grow.
It is the baseline moisture reading of dry materials in your house. Wet materials are dried until they match.
GPP is a measure of moisture in the air. Lower GPP means faster drying.
Yes. Air movers and dehumidifiers are noisy and add heat. Most people can stay home, but you may want to close doors to the drying area at night.
No. A Water Damage is a free referral service that connects you with independent, licensed and insured local contractors who perform the drying.

Calls from Colquitt and zip codes such as 39837 are routed to structural drying pros working locally.
Nearby cities are listed below.
