After a leak, the surfaces dry fast while the structure stays wet. Framing, subfloors, and wall cavities hold moisture you cannot see. Structural drying uses measured airflow and dehumidification to bring those materials back to normal moisture levels.
Free referral to independent, licensed and insured local pros. Zip codes served include 33322 33323 33324 33325 33317 33313 33388 33318 33329 33337.

Drying is where most do-it-yourself cleanups fail. A Water Damage is a free referral service connecting you with independent, licensed and insured drying contractors near Plantation who use psychrometrics, not guesswork, to decide where equipment goes and when it comes out.
LGR dehumidifiers, desiccants for tough jobs, and air movers placed with purpose, not just pointed at the wall.
The contractor records temperature, relative humidity, GPP, and material moisture each day, then adjusts equipment based on the numbers.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
Drying is usually billed by equipment per day plus monitoring visits. You get the rates and an estimated number of days in writing.

Good drying starts with a moisture map and ends with readings that match dry standard. Everything in between is about controlling air, temperature, and humidity.

Meters and thermal imaging trace water into hidden spots before drying begins.
Sealing off the wet area with plastic focuses the equipment and shortens drying time.
Injecting dry air through small holes can dry wall cavities without full flood cuts.
Hardwood and subfloors are dried with mats and controlled airflow to reduce cupping.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
A local contractor calls back with an arrival time and brings meters, a thermal camera, and an initial set of drying equipment.
You get a moisture map, a dry standard baseline, and a written drying plan with costs.
Drying continues with daily monitoring until readings confirm the job is done.
Closing up wet framing is how mold starts.
We had fans running for a week after a leak and it still smelled. The drying contractor found wet studs with a thermal camera and had them dry in four days with real equipment.
Laura F.Hidden wet framing after leakWall injection drying saved our drywall. Just a few small holes behind the baseboards.
Kevin Y.Wall cavity dryingI liked seeing the daily log. Humidity numbers, wood readings, all of it. The adjuster liked it too.
Mariah S.Insurance drying documentationThey saved our cupping hardwood with floor mats and patient drying.
Henry L.Hardwood floor drying

Most jobs take three to five days. Dense materials like hardwood, plaster, and concrete can take a week or longer.
Household units move far less air and cannot reach the low humidity levels needed to pull moisture out of framing and subfloors. Drying slowly also gives mold time to grow.
Dry standard is the normal moisture reading of the same type of material in an unaffected part of the home. Drying is complete when wet materials match it.
Grains per pound, or GPP, measures how much water vapor is in the air. Lowering GPP in the drying area speeds evaporation from wet materials.
It is loud and warm. Closing off the drying area helps at night.
No. We connect you with independent local pros. Confirm their license and insurance before work starts.

Calls from Plantation and zip codes such as 33322 33323 33324 33325 33317 33313 33388 33318 33329 33337 are routed to structural drying pros working locally.
Nearby cities are listed below.
