The visible water is gone, the carpet looks fine, and someone told you a couple of fans would finish it off. But the studs behind the drywall are still reading wet, the subfloor is holding moisture, and the house smells a little off. Structural drying is how you get the framing, subfloor, and walls truly dry before anything gets closed up.
Free referral to independent, licensed and insured local pros. Zip codes served include 81151.

We are a referral line, not a contractor. Calls are routed to independent local pros around Sanford who treat drying as a measured process with daily readings and written logs.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
The contractor records temperature, relative humidity, GPP, and material moisture each day, then adjusts equipment based on the numbers.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
Drying is usually billed by equipment per day plus monitoring visits. You get the rates and an estimated number of days in writing.

Good drying starts with a moisture map and ends with readings that match dry standard. Everything in between is about controlling air, temperature, and humidity.

Pin and pinless meters plus an infrared camera show exactly where water traveled, including under cabinets, inside walls, and across the subfloor.
Plastic containment creates a smaller drying chamber, so dehumidifiers work on a defined space and drying moves faster.
Injecting dry air through small holes can dry wall cavities without full flood cuts.
Floor mat systems and targeted airflow dry hardwood and plywood subfloors slowly enough to limit cupping and cracking.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
A local contractor calls back with an arrival time and brings meters, a thermal camera, and an initial set of drying equipment.
The pro maps moisture, records dry standard from unaffected areas, calculates equipment needs, and gives you a written estimate.
Drying continues with daily monitoring until readings confirm the job is done.
Get readings before you rebuild.
We had fans running for a week after a leak and it still smelled. The drying contractor found wet studs with a thermal camera and had them dry in four days with real equipment.
Laura F.Hidden wet framing after leakWall injection drying saved our drywall. Just a few small holes behind the baseboards.
Kevin Y.Wall cavity dryingI liked seeing the daily log. Humidity numbers, wood readings, all of it. The adjuster liked it too.
Mariah S.Insurance drying documentationOur oak floor was cupping. They used floor mats and kept the drying slow and steady. The boards flattened back out.
Henry L.Hardwood floor drying

Most jobs take three to five days. Dense materials like hardwood, plaster, and concrete can take a week or longer.
Consumer equipment is too weak to dry framing quickly enough to prevent mold.
It is the baseline moisture reading of dry materials in your house. Wet materials are dried until they match.
Grains per pound, or GPP, measures how much water vapor is in the air. Lowering GPP in the drying area speeds evaporation from wet materials.
It is loud and warm. Closing off the drying area helps at night.
No. A Water Damage is a free referral service that connects you with independent, licensed and insured local contractors who perform the drying.

Calls from Sanford and zip codes such as 81151 are routed to structural drying pros working locally.
See nearby cities in the list below.
