After a leak, the surfaces dry fast while the structure stays wet. Framing, subfloors, and wall cavities hold moisture you cannot see. Structural drying uses measured airflow and dehumidification to bring those materials back to normal moisture levels.
Free referral to independent, licensed and insured local pros. Zip codes served include 80128 80123.

Drying is where most do-it-yourself cleanups fail. A Water Damage is a free referral service connecting you with independent, licensed and insured drying contractors near Columbine who use psychrometrics, not guesswork, to decide where equipment goes and when it comes out.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
The contractor records temperature, relative humidity, GPP, and material moisture each day, then adjusts equipment based on the numbers.
Ask for proof of license and insurance before work begins.
Drying is usually billed by equipment per day plus monitoring visits. You get the rates and an estimated number of days in writing.

The goal is simple: get every wet material back to the moisture level of similar dry materials in the house, and prove it with readings.

Pin and pinless meters plus an infrared camera show exactly where water traveled, including under cabinets, inside walls, and across the subfloor.
Plastic containment creates a smaller drying chamber, so dehumidifiers work on a defined space and drying moves faster.
Injecting dry air through small holes can dry wall cavities without full flood cuts.
Floor mat systems and targeted airflow dry hardwood and plywood subfloors slowly enough to limit cupping and cracking.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
A local contractor calls back with an arrival time and brings meters, a thermal camera, and an initial set of drying equipment.
You get a moisture map, a dry standard baseline, and a written drying plan with costs.
Drying continues with daily monitoring until readings confirm the job is done.
Closing up wet framing is how mold starts.
We had fans running for a week after a leak and it still smelled. The drying contractor found wet studs with a thermal camera and had them dry in four days with real equipment.
Laura F.Hidden wet framing after leakThey drilled small holes behind the baseboards and pumped dry air into the walls. We did not have to tear out any drywall.
Kevin Y.Wall cavity dryingThe daily drying logs were detailed and made the insurance claim straightforward.
Mariah S.Insurance drying documentationThey saved our cupping hardwood with floor mats and patient drying.
Henry L.Hardwood floor drying

Most jobs take three to five days. Dense materials like hardwood, plaster, and concrete can take a week or longer.
Consumer equipment is too weak to dry framing quickly enough to prevent mold.
It is the baseline moisture reading of dry materials in your house. Wet materials are dried until they match.
GPP is a measure of moisture in the air. Lower GPP means faster drying.
Yes. Air movers and dehumidifiers are noisy and add heat. Most people can stay home, but you may want to close doors to the drying area at night.
No. A Water Damage is a free referral service that connects you with independent, licensed and insured local contractors who perform the drying.

Independent drying specialists in the network serve Columbine, CO and nearby zip codes like 80128 80123.
Nearby cities are listed below.
