Lab numbers, not guesswork
When you need actual data on what's in the air, a swab from a hardware store kit won't cut it. One call connects you with a licensed independent sampling pro near Bourg who collects spore-trap air samples and surface samples and sends them to an accredited lab.
ESS Mold Inspection is a free referral service. Samples are collected by independent local professionals and analyzed by third-party labs.
How sampling works
Mold testing is lab science. For air, the sampling pro attaches a sealed spore-trap cassette to a pump calibrated with a rotameter, then runs it at a set flow rate, often 15 liters per minute for 5 minutes, which pulls 75 liters of air across a sticky slide. The lab counts and identifies what landed on that strip under a microscope, then converts the count to spores per cubic meter of air.
A single indoor count tells you very little without a comparison. Outdoor air always carries spores, which is why a control sample gets taken outside during the same visit. The analysis uses rank order: indoor air in a healthy house usually mirrors the outdoor mix at lower numbers, so a spore type that tops the indoor list but barely appears outside is a red flag. There are no federal numeric limits for indoor spores, which is exactly why the outdoor comparison carries so much weight.
When there's a visible spot and you want it identified, surface samples come in. A tape-lift presses clear adhesive tape onto the growth, a swab works on rough or curved surfaces, and a bulk sample is a cut piece of drywall, carpet or insulation sent whole. A wall-cavity air sample, drawn through a tiny hole, can show whether a closed cavity is loaded with spores. Most Bourg callers want testing for paperwork: a real estate disclosure, a tenant complaint, or proof a cleanup worked.
What separates good sampling
Lab results are only as reliable as the way the samples were collected, handled and shipped.
Sampling pros in the network are independent, insured, and licensed where a state requires a license for mold assessment. Because they aren't selling the remediation, they have no reason to steer results.
Clearance tests often hold up a containment teardown or a closing, so timing matters. Tell the dispatcher it's a clearance or a closing, and the call is routed to a Bourg pro who can sample soon; same-day is common.
Testing is usually priced as a site fee plus a per-sample lab charge, and rush turnaround costs extra. The written quote lists the expected sample count and the lab fees so the bill doesn't surprise you.
Look for a high-volume air pump with a rotameter calibration check before and after each run, sealed spore-trap cassettes, tape-lift slides, sterile swabs and sealed bags for bulk samples. Results are only defensible with an AIHA-LAP accredited lab and a signed chain-of-custody form tracking each sample from collection to analysis.
Sampling methods
Each sampling method answers a specific question, so the dispatcher asks what you need the results for before routing your call.
This is the workhorse test. Each indoor cassette is paired with an outdoor control, and the lab report lists every spore type with its count per cubic meter.
For a visible stain, tape-lift and swab samples confirm whether it's fungal growth and identify it, while bulk samples handle porous materials.
A small hole and a short sample run can show whether a closed stud bay is full of spores. Results are read differently from room air, since cavities are closed spaces.
The ERMI test runs DNA analysis on a dust sample and scores the home against a national database. Treat it as a screen: it shows history in the dust, not what's airborne today, so most pros pair it with air samples.
Clearance happens while containment is still up: inside and outdoor air samples, plus surface samples if needed, document that the cleanup worked. The clearance report becomes the paperwork for disclosure forms, insurance and lease files.
The line routes you to a local, insured pro who pulls calibrated samples and ships them under chain of custody.
How it works
The process is simple, and the quote comes before the pump comes out.
Expect questions about the purpose of the test, the areas of concern and any deadline you're working against.
An independent sampling pro in Bourg confirms the appointment, and urgent clearance requests are prioritized. Keep windows closed and skip the vacuuming for a day beforehand so the air reflects normal conditions.
On site, the pro checks the pump flow, runs the outdoor and indoor samples, and records times, volumes and locations. Any change to the sample count gets priced before it's taken.
The lab typically turns results around in one to three days, faster with rush service, and the pro walks you through the report.
From the dispatch log
These situations come through the line all the time.
A seller had a basement remediated and the buyer's agent asked for proof the job was finished. The sampling pro pulled air samples inside the work area and outdoors while containment was still up, plus a tape-lift from the cleaned framing. The accredited lab showed indoor counts below outdoor levels with a similar spore mix.
Outcome: The seller attached the lab report and chain-of-custody form to the disclosure, and the sale moved forward.
After a leaking window wet the bedroom carpet, a parent wanted lab data before letting the child sleep there again. The pro took bedroom and hallway air samples plus an outdoor control. The bedroom showed elevated Penicillium and Aspergillus spores compared to outdoors.
Outcome: The results supported replacing the carpet pad, and the parent shared the report with the child's pediatrician.
A caller's store-bought petri dish grew several colonies, and they were sure the house was contaminated. The sampling pro explained that spores are always present in air, so a settle plate almost always grows something. Calibrated air samples with an outdoor control showed indoor counts well below outdoor counts.
Outcome: Real lab data replaced the dish result, and the homeowner skipped an unnecessary remediation estimate.
A renter and a property manager disagreed about whether a closet smell needed attention. The tenant called for independent testing. The pro took a wall-cavity sample behind the closet, a room air sample and an outdoor control, all sent under chain of custody.
Outcome: The cavity sample showed high Stachybotrys counts, giving both sides lab data to work from.
These are composite examples based on common calls to the line, not individual customer reviews.
Questions
One call connects you with a local sampling pro in Bourg who works with accredited labs.
Call +1-844-326-4757Not in any useful way. Since spores are always present indoors and out, a dish will grow colonies in nearly any house, and it gives no measured air volume and no outdoor comparison. For a real answer, you need a measured air sample and an outdoor control analyzed by an accredited lab.
Most labs return results within one to three business days of receiving the cassettes. Rush and same-day processing are usually available for an added fee, which helps when a closing or a containment teardown is waiting.
No federal agency sets a safe indoor spore count. Results are read against the outdoor baseline and by spore type, not against a fixed threshold. If anyone in the home has asthma, allergies or a weakened immune system, share the report with their doctor.
It sets the baseline everything else is measured against. Because spore levels outside swing with rain, wind and season, the pro samples outdoors during the visit to capture that day's normal. When indoor counts run higher than outdoor, or the indoor mix looks different, it suggests an indoor source.
To a degree, yes. Spore-trap and tape-lift analysis under a microscope usually identifies mold to the genus level, such as Aspergillus, Penicillium, Cladosporium or Stachybotrys, but some spores look nearly identical and get grouped. Species-level identification requires culture or DNA methods, which cost more and take longer.
Clearance testing confirms a remediation worked, using air and sometimes surface samples taken inside containment before it's removed, compared to an outdoor control. It's worth it when you need documentation for a sale, a lease or insurance, or when someone in the house is sensitive. Have it done by a tester separate from the remediation company.
Service area
Testing calls come in from all over Bourg, including houses getting ready to list, rental units with tenant complaints and homes finishing remediation. Your call goes to a licensed, independent pro close by who sends samples to an accredited lab and can work around your deadline.
For clearance work, time the call so the samples are pulled while containment is still standing. When there's a closing or lease date, say so on the call so rush turnaround can be priced right away.
