Physical removal, not another coat of paint
Growth that creeps across a ceiling, a closet or a sink cabinet has to be physically taken out, because covering it only hides it for a season. One call connects you with an independent local remediator in Westwego who works behind plastic sheeting, under negative air, and takes out what can't be saved.
ESS Mold Inspection is a free referral line. Every job is performed by an independent local contractor, not by ESS Mold Inspection.
What removal really involves
Most removal calls start the same way: a small gray or green spot shows up on a closet wall, under a sink or along a bedroom window sill, and a few weeks later it covers a much bigger area. What feeds the growth is nearly always moisture, whether it's a drip from a supply line, condensation on single-pane glass or a bathroom upstairs that has been leaking quietly.
Removal means contaminated material either leaves the house or gets cleaned down to sound surface. Drywall gets cut out past the visible edge, because growth runs further than the stain you can see. Carpet pad, wet insulation and swollen particleboard go into 6-mil bags, get sealed, and get bagged a second time before they cross a clean room. Structural wood like studs and subfloor usually stays. It gets wire brushed or sanded, HEPA vacuumed and damp wiped until it's clean to the touch and clean under a work light.
Bleach and store-bought sprays are the reason plenty of people call the line a second time. Bleach can whiten the stain, but it doesn't pull growth out of porous drywall paper, and the water in it can feed what's left. Antimicrobials have a place after cleaning, but they are not a substitute for taking the material out. For homeowners in Westwego, the last piece is drying: framing gets checked with a moisture meter and has to reach target readings before anyone hangs new board.
Why callers use the line
Every contractor you reach through the line is independent, and the dispatcher's job is matching your problem with someone who does physical removal by the book.
You're matched with an independent remediator who is insured and, where the state requires it, licensed for mold work. It's fair to ask for proof of coverage before work starts.
Same-day site visits are common in most areas, and urgent calls, like a buyer's inspection deadline or a leak that's still dripping, are prioritized.
You get a written scope and price after the walkthrough and before a single cut is made, including how much drywall comes out and how the room will be sealed off.
The right contractor arrives with poly sheeting and zipper doors, a HEPA negative air machine, HEPA vacuums, pin and pinless moisture meters, plus wire brushes and sanders for framing.
What the work covers
These are the pieces of a typical residential removal. Your quote should spell out which of them apply to your house.
The first hour is usually spent building containment: 6-mil poly walls, a zipper door, and a HEPA negative air machine that keeps the work zone at lower pressure than the rest of the house.
Paper-faced drywall with growth on it gets removed, not scrubbed. The remediator cuts beyond the visible edge, then opens the wall or ceiling cavity to see how far the moisture traveled.
Carpet pad, fiberglass batts, cardboard boxes and swollen particleboard cabinet floors absorb growth deep into the material. They get misted, bagged in 6-mil bags, sealed, bagged again and carried out through the containment.
Solid wood rarely needs replacing. The contractor wire brushes or sands the affected framing, follows with a HEPA vacuum and damp wipe, and repeats until the wood is visibly clean.
Cleaning is only half the job. The area stays dried with dehumidification until the moisture meter shows target readings, and then it's turned over to whoever is handling drywall, paint and trim.
Every week a patch keeps growing, the cut line moves further out. Call now and the dispatcher connects you with an independent local remediator who can schedule a walkthrough.
How dispatch works
The path is short, and nothing gets cut until you've approved a written scope.
The dispatcher asks where the growth is, roughly how many square feet it covers, what the water source was and whether it's been fixed. EPA suggests professional help once mold covers more than about 10 square feet.
The contractor arrives, checks the wall or ceiling with a moisture meter, and looks for the leak, the condensation point or the failed seal that started it.
The remediator measures the area, marks the cut lines, explains what's porous and what's cleanable, and gives you a written quote before any work starts.
The job wraps with HEPA vacuuming, damp wiping, a visual inspection and dry moisture readings. In some states the clearance check has to come from a different company than the one that did the removal.
From the dispatch log
A few patterns come up again and again. Here's how those calls usually go.
A seller called after the buyer's inspector flagged a musty utility closet. Behind the shelving, the drywall shared with the water heater closet was dark along the bottom foot, fed by a weeping relief valve line. The remediator contained the closet, cut the board out to the next stud bay and cleaned the bottom plate.
Outcome: The valve was fixed by a plumber, framing dried to target readings, and the seller had documentation to give the buyer.
After years of bleaching the same window sills each winter, one caller found the drywall under them crumbling. The contractor took out the returns and trim, cleaned the rough opening, and explained that condensation on the glass was feeding it.
Outcome: Damaged returns were replaced, and a dehumidifier plus better bedroom airflow kept humidity in the 30 to 50 percent range.
Someone noticed the sink cabinet floor had swollen and smelled sour. A slip nut on the trap had been seeping for months. The particleboard floor and the drywall behind the cabinet back both had growth, so the contractor pulled the cabinet, bagged the ruined parts and cleaned the wall framing.
Outcome: Once the framing dried, the cabinet was reset on a new floor panel and the trap was replaced.
A brown ring on a living room ceiling turned into a gray, fuzzy patch about the size of a doormat. The toilet wax ring upstairs had failed. The contractor set up containment under the bathroom, cut the ceiling back past the growth, bagged the wet insulation and cleaned the joists.
Outcome: The toilet was reset, the joists dried out, and the ceiling was closed back up with new board.
These are composite examples based on common calls to the line, not individual customer reviews.
Questions callers ask
Not sure if your patch needs a pro? Call and describe it. The dispatcher can tell you what an independent remediator will likely look at.
Call +1-844-326-4757Bleach can whiten the surface, but on porous materials like drywall paper, ceiling texture and raw wood it doesn't remove the growth underneath, and the water in it can feed what's left. That's why so many sprayed patches come back. Small spots on hard, nonporous surfaces can be cleaned with detergent and water, but growth in drywall has to be cut out.
A single closet wall or sink cabinet is often a one-day job for containment, removal and cleaning. Larger ceiling or multi-room jobs can run two to four days. Drying the framing to target readings can add a few more days before rebuild, and your written quote should give a time estimate.
In most cases no. The containment and HEPA negative air are there so you can keep living in the rest of the house. Anyone with asthma, allergies or a weakened immune system should check with their doctor about whether to stay elsewhere during the work.
Porous materials with growth in them, like drywall, carpet pad, insulation and particleboard, generally get bagged and removed. Solid wood framing, subfloor, metal and other hard surfaces can usually be wire brushed or sanded, HEPA vacuumed and damp wiped clean.
It returns when the water problem isn't solved. Fix the leak or the condensation, keep indoor humidity under 60 percent (30 to 50 is better), and dry any future spill within 24 to 48 hours. Ask the contractor what written workmanship terms they offer.
It depends on the cause and your policy. Mold from a sudden, covered water event, like a burst supply line, is sometimes covered, often with a sublimit. Mold from a long-term leak or ongoing humidity usually isn't. Read your policy or call your agent before work starts, and keep photos.
Service area
Whether you're in an older home near downtown Westwego or a newer build on the edge of town, the dispatcher can match you with an independent local remediator who does residential removal. Older homes usually call about closets, crawl-adjacent floors and plumbing walls. Newer, tighter homes call more about condensation on windows and cold corners.
If you're facing a closing date, an inspection report or a patch that keeps spreading, call +1-844-326-4757 and describe what you're seeing. You'll get a written quote before anything is cut.
