Find the water first, then the mold
A musty smell with nothing showing on the walls usually means water is getting somewhere you can't see. Call the line and we match you with an independent licensed inspector near Chattanooga who traces the water with meters and thermal imaging before anyone talks about tearing out drywall.
ESS Mold Inspection is a free referral line. Every inspection is performed by an independent local contractor, never by the line itself.
What an inspection actually is
A real mold inspection is a field investigation, not a sales visit. The inspector walks the property room by room, looks at ceilings, baseboards, window sills and the backs of closets, and takes moisture readings along the way. Pin-type meters push two small probes into drywall or trim to read moisture content at that exact spot, while pinless meters sweep across a wall to find damp zones without leaving marks. Those readings get plotted on a sketch of the floor plan, which is what people in the trade call moisture mapping.
Thermal imaging won't show mold growth directly, no matter what the ads suggest. It shows temperature differences, and wet drywall or insulation usually reads cooler than the dry material around it, so a cold streak under a window tells the inspector exactly where to put a meter. A hygrometer gives relative humidity and dew point for each area. If the dew point sits close to the surface temperature of a wall, a duct or a window frame, condensation is forming there. When something looks suspicious inside a wall cavity, the inspector can usually slip a borescope through a pencil-sized hole and see the back of the drywall, the studs and the insulation without cutting anything open.
The step most people skip is the one that matters most: finding where the water comes from. Kill the mold without fixing the source and it grows back, often within a season. That's why the inspector checks the HVAC air handler, the evaporator coil, the condensate drip pan and drain line, the attic decking and vents, and the crawl space vapor barrier and joists, not just the room that smells. Callers in Chattanooga usually reach the line for one of a few reasons: a home purchase, a past leak they're not sure was dried, a smell that won't quit, or a dispute with a landlord.
What you should expect
Callers use the line because it connects them with inspectors who do the moisture work properly and stay out of the remediation business on that job.
Every inspector the line routes to runs an independent business with liability coverage and any state mold assessor license that applies. Independence from the remediator matters: an inspector with no cleanup to sell has no reason to make the problem look bigger than it is.
Inspection calls are rarely emergencies, but real estate deadlines are. Mention your closing or contingency date on the call and the dispatcher prioritizes inspectors around Chattanooga who can get out soon; same-day is common for an active leak.
Inspectors typically price by home size and how many spaces need checking, including attics, crawl spaces and mechanical closets. The quote comes before the visit; if the inspector thinks a lab sample could help, ask for the per-sample cost in writing ahead of time.
Expect pin-type and pinless moisture meters, an infrared camera, a thermo-hygrometer, a borescope and a strong flashlight, plus a ladder for the attic hatch. An inspector who never takes a moisture reading isn't doing the job, so ask about equipment when you book.
Inspection types
Different situations call for different inspections, and the dispatcher will ask a few questions so the right inspector shows up with the right gear.
Built around your option or contingency deadline, this visit looks for evidence of past and present water: stains under fresh paint, warped baseboards, rust on the water heater pan, efflorescence on basement block.
When a smell shows up but growth doesn't, the inspector follows the odor room by room, scanning plumbing walls, laundry areas and exterior corners for cool, damp spots.
A clogged condensate line or a pan that never drains can feed growth on the evaporator coil and inside the air handler cabinet, then push that odor through every supply register.
Up top, it's about ventilation and roof leaks: blackened sheathing, rusty nail tips, crushed insulation and bathroom exhaust ducts that end in the attic instead of outside. Under the house, the checks cover wood moisture in joists and sill plates, the condition of the vapor barrier, and any pooling water.
After the cleanup crew says they're done, an independent inspector checks that the protocol was followed: visible growth gone, framing dry, containment still intact, and the original moisture source repaired. If you also want lab clearance, that's a separate step and the inspector can tell you whether it makes sense.
One call puts you in touch with an independent, licensed inspector in Chattanooga who maps the moisture and explains what's behind the finish.
How it works
Four steps, and you know the price before anyone pulls into your driveway.
The dispatcher asks why you need the inspection, how big the home is, whether there's an attic or crawl space, and if there's a real estate deadline.
A local inspector calls to set the appointment; active water problems are prioritized. It helps to clear the path to the attic hatch, the furnace closet and the crawl space door.
The inspector walks every room, maps moisture with meters, scans with an infrared camera, logs humidity and dew point, and checks the HVAC, attic and crawl space. Any extra work, like lab samples, gets priced before it's done.
The final report lays out photos, readings, the cause and a protocol, so remediators bid on the same scope.
From the dispatch log
A few patterns show up on the line over and over.
A caller described a smell that only showed up when the cooling ran, and nothing on the walls or ceilings looked wrong. The inspector found the condensate drain line clogged with slime, the drip pan overflowing, and wet insulation inside the air handler cabinet. Thermal imaging showed a damp patch on the closet ceiling below.
Outcome: The report pointed to the drain line and air handler, not the bedrooms, so cleanup stayed small and focused.
A buyer under contract noticed one bathroom ceiling looked newly painted and called with five days left in the option period. The inspector's pinless meter found elevated moisture under the paint, and a borescope through a small hole showed staining on the back of the drywall from a leaking shower valve above.
Outcome: The buyer used the written report to negotiate a repair credit before the option period closed.
A condo owner called after the unit upstairs had a dishwasher leak that the association said had been dried. Weeks later the kitchen ceiling had a faint ring. Moisture mapping found the wet area ran past the ring, and the dew point readings ruled out condensation as the cause.
Outcome: The report documented the extent of the moisture so the owner had evidence for the association and insurance.
A parent reached the line after months of stuffy noses that seemed to ease whenever the family traveled. Room humidity sat near 70 percent. The inspector found a crawl space with a torn vapor barrier, damp joists, and gaps letting crawl space air into the return duct.
Outcome: The scope covered the vapor barrier, air sealing and humidity control, and the family took the report to their doctor.
These are composite examples based on common calls to the line, not individual customer reviews.
Questions
Call the line and get routed to an independent, licensed inspector near Chattanooga.
Call +1-844-326-4757Inspection answers where and why. It's a site visit built on moisture readings, thermal scans and tracing the water source. Testing is narrower and means collecting samples for a lab. Plenty of inspections never need one, because visible growth plus a wet reading already tells the story.
For a typical single-family home in Chattanooga, plan on two to three hours on site. Bigger homes, finished basements, tight crawl spaces and multiple HVAC systems add time, and so does borescope work inside walls. The written report usually follows within a day or two.
In most cases, no. Moisture meters and an infrared camera work from the surface, and when the inspector needs to see inside a cavity, the standard move is a small drilled hole for a borescope. Anything bigger should be discussed and approved by you first, and in a rental, by the owner.
It's the cleaner setup, yes. When the company that finds the mold also gets paid to remove it, there's an obvious incentive to write a bigger scope. Some states require that separation for the same project. Where they don't, it's still smart: the independent inspector writes the protocol and the remediators bid against it.
No rule requires one, though it makes sense when the listing or the general home inspection hints at water, like stains, a sump pit or a musty lower level. Book it early so the report lands before your option or contingency period ends, while you still have leverage.
Expect labeled photos, a moisture map with the readings, humidity and dew point figures for each area, and the thermal images that flagged a problem. It should name the likely moisture source and include a remediation scope or protocol covering what to remove, the containment needed and how the work gets verified.
Service area
Calls come in from every part of Chattanooga, whether it's a slab home with a closet air handler, a house over a damp crawl space, or a condo sharing walls and ceilings with neighbors. The dispatcher matches you with a nearby independent inspector who works separately from the cleanup side.
If you're under contract, mention the deadline first. With water actively coming in, stop it at the valve if possible, then call so the moisture can be mapped while it's still fresh.
