Find the water first, then the mold
A musty smell with nothing showing on the walls usually means water is getting somewhere you can't see. The dispatcher connects you with a licensed and insured independent inspector in Janesville who finds the wet spot, the cause and the scope, and puts it all in writing.
ESS Mold Inspection is a free referral line. Every inspection is performed by an independent local contractor, never by the line itself.
What an inspection actually is
A real mold inspection is a field investigation, not a sales visit. The inspector walks the property room by room, looks at ceilings, baseboards, window sills and the backs of closets, and takes moisture readings along the way. Pin-type meters push two small probes into drywall or trim to read moisture content at that exact spot, while pinless meters sweep across a wall to find damp zones without leaving marks. Those readings get plotted on a sketch of the floor plan, which is what people in the trade call moisture mapping.
An infrared camera doesn't actually see mold. What it picks up is temperature, and since evaporating moisture cools a surface, damp spots behind paint show up as cooler patches that the inspector then confirms with a meter. A hygrometer gives relative humidity and dew point for each area. If the dew point sits close to the surface temperature of a wall, a duct or a window frame, condensation is forming there. When something looks suspicious inside a wall cavity, many inspectors drill a hole about the width of a pencil and look in with a borescope rather than opening up the drywall.
Here's what separates a useful inspection from a wasted afternoon: did anybody find the moisture source? If the leak, the condensation or the drainage problem stays, any cleanup is temporary. That's why the inspector checks the HVAC air handler, the evaporator coil, the condensate drip pan and drain line, the attic decking and vents, and the crawl space vapor barrier and joists, not just the room that smells. Callers in Janesville usually reach the line for one of a few reasons: a home purchase, a past leak they're not sure was dried, a smell that won't quit, or a dispute with a landlord.
What you should expect
Callers use the line because it connects them with inspectors who do the moisture work properly and stay out of the remediation business on that job.
Every inspector the line routes to runs an independent business with liability coverage and any state mold assessor license that applies. Independence from the remediator matters: an inspector with no cleanup to sell has no reason to make the problem look bigger than it is.
A home purchase with a short option period can't wait two weeks for an inspector. Tell the dispatcher your contingency date and the call gets routed to someone near Janesville with an open slot, and same-day visits are common when water is actively coming in.
Inspection pricing usually depends on square footage, the number of areas, and whether attic and crawl space access is needed. You get the price before anyone arrives, and if lab samples might be added on site, ask how they're billed per sample before the visit.
Expect pin-type and pinless moisture meters, an infrared camera, a thermo-hygrometer, a borescope and a strong flashlight, plus a ladder for the attic hatch. If the person who shows up carries a swab kit but no meter, that's not an inspection.
Inspection types
Different situations call for different inspections, and the dispatcher will ask a few questions so the right inspector shows up with the right gear.
This one is timed to your contingency window and focuses on the signs sellers sometimes paint over: ceiling stains, swollen trim, a rusty water heater pan, white mineral bloom on foundation walls.
When a smell shows up but growth doesn't, the inspector follows the odor room by room, scanning plumbing walls, laundry areas and exterior corners for cool, damp spots.
A clogged condensate line or a pan that never drains can feed growth on the evaporator coil and inside the air handler cabinet, then push that odor through every supply register.
In the attic, the inspector looks for dark staining on roof decking, frost or condensation on nails, blocked soffit vents and bath fans that dump air into the insulation. Under the house, the checks cover wood moisture in joists and sill plates, the condition of the vapor barrier, and any pooling water.
Once remediation wraps up, a separate inspector confirms the work matches the written scope, from dry readings on the studs to an undisturbed containment barrier and a fixed leak. If you also want lab clearance, that's a separate step and the inspector can tell you whether it makes sense.
Call the line and get matched with a local independent inspector who'll trace the water, document it and hand you a written scope.
How it works
Four steps, and you know the price before anyone pulls into your driveway.
The dispatcher asks why you need the inspection, how big the home is, whether there's an attic or crawl space, and if there's a real estate deadline.
An independent inspector near Janesville confirms a time, and same-day visits are common for active leaks. Clear access to the attic hatch, the air handler and under sinks before they arrive.
The inspector walks every room, maps moisture with meters, scans with an infrared camera, logs humidity and dew point, and checks the HVAC, attic and crawl space. If extra work like sampling comes up, you see the cost first.
The final report lays out photos, readings, the cause and a protocol, so remediators bid on the same scope.
From the dispatch log
These are the kinds of inspection calls that come in every week.
A caller described a smell that only showed up when the cooling ran, and nothing on the walls or ceilings looked wrong. The inspector found the condensate drain line clogged with slime, the drip pan overflowing, and wet insulation inside the air handler cabinet. Thermal imaging showed a damp patch on the closet ceiling below.
Outcome: The report pointed to the drain line and air handler, not the bedrooms, so cleanup stayed small and focused.
With less than a week before the contingency deadline, a buyer called because a single ceiling had suspiciously fresh paint. The inspector's pinless meter found elevated moisture under the paint, and a borescope through a small hole showed staining on the back of the drywall from a leaking shower valve above.
Outcome: The buyer used the written report to negotiate a repair credit before the option period closed.
After an upstairs dishwasher leak, a condo owner wanted to know whether the shared ceiling had actually dried out. Weeks later the kitchen ceiling had a faint ring. Moisture mapping found the wet area ran past the ring, and the dew point readings ruled out condensation as the cause.
Outcome: The report documented the extent of the moisture so the owner had evidence for the association and insurance.
A parent reached the line after months of stuffy noses that seemed to ease whenever the family traveled. Room humidity sat near 70 percent. The inspector found a crawl space with a torn vapor barrier, damp joists, and gaps letting crawl space air into the return duct.
Outcome: The scope covered the vapor barrier, air sealing and humidity control, and the family took the report to their doctor.
These are composite examples based on common calls to the line, not individual customer reviews.
Questions
Call the line and get routed to an independent, licensed inspector near Janesville.
Call +1-844-326-4757Inspection answers where and why. It's a site visit built on moisture readings, thermal scans and tracing the water source. Testing only refers to the lab samples, and many inspections skip them, since a wet wall with visible growth doesn't need a lab to confirm it.
Most houses take somewhere between two and three hours from arrival to wrap-up. Bigger homes, finished basements, tight crawl spaces and multiple HVAC systems add time, and so does borescope work inside walls. The written report usually follows within a day or two.
Usually not. Moisture meters and an infrared camera work from the surface, and when the inspector needs to see inside a cavity, the standard move is a small drilled hole for a borescope. Anything bigger should be discussed and approved by you first, and in a rental, by the owner.
It's the cleaner setup, yes. An inspector who also sells remediation has a reason to find more work than the house needs. Some states prohibit one company from doing both on a single job, and even where it's allowed, a separate inspector gives you a scope you can take to several remediators.
It's not required, but it's worth it if the house shows any history of water: a finished basement, a crawl space, an older roof, or fresh paint in odd spots. Schedule it right after your offer is accepted, so you have the report while you can still renegotiate or walk away.
A useful report has photos of each problem area, moisture readings and where they were taken, humidity and dew point by room, and thermal images with notes. The part you'll use most is the protocol, which spells out what to remove, the containment and air filtration, the moisture repair, and how the finished job gets checked.
Service area
The line routes inspection calls throughout Janesville, from older homes with plaster walls and original ductwork to newer builds with tight envelopes that trap humidity. Wherever you are, the dispatcher looks for an independent inspector who can get there soon and who isn't tied to the remediation work.
If there's a closing date, say so at the start of the call. For an active leak, shut off the water if you can and call the line so a local inspector can trace how far the moisture has spread.
